What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 18.06.2025 00:48

[image of Common-mode choke]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
It also is a device that limits the change in current flow.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Le Mans 24 Hours: Kubica wins with Ferrari as Porsche spoils 1-2-3 - Autosport
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
For this case there are devices called Metal oxide varistors (MOV).
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
When was you wife swapping fantasy started?
Now when you have a certain ac resistance, then a current flows in a loop.
eight
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
what exactly is a ‘surge’ protector?
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
What are some reasons why men may not want to date a woman who can pay her own bills?
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Because the load is inductive, the current lags the voltage.(by a bit).
a photo is worth a thousand words.
My blog is new. I need 10 article posts for my blog. How much should I pay for it?
So, the voltage could go up to 500 volts, and the fuse will not open up.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
At one ohm, the resistor has a maximum of 1 watt power.
Study Reveals How Much Exercise You Need Each Week to Control Blood Pressure - ScienceAlert
The third is lightning and “how it gets conducted into a home.”
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
the problem then depends on "how fast does the fuse operate?".
But it can get overloaded, and no longer works.
These are simplified answers to the original question, and does not change anything I wrote above.
Here is a simplified AC power diagram.
How can I decorate my house creatively?
He then describes the function of a fuse.
The other is “what does a “fuse” do?”
This is 'the assistant's answer'
Do you think the constitution and laws should be taught in school?
A fuse is a non-resetable over current circuit protector.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
so, what happens?
This is where the MOV conducts again, and dissipated the energy.
These devices are installed between the “hot” and “neutral” and protective ground.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
There are three different concepts here that are getting confused.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This device then solves the entire problem.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Barnstars:
2024–10–14 [Omar Gharbi Omar Gharbi ]
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
What is lightning?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
I post the exact comment here.
but this device (an Inductor) … impedes the rapid changes in the current.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
One is “what exactly is in a ‘surge protector’ ? ”
There are two important concepts here.
(Dc diagram shown, AC is similar).
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
nine
But… the neutral is now “floating” because of the 1 ohm resistance.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
At least they know the answer if they wanted it.
The bolt then partially travels down the line to your home.
[old diagram got deleted by accident]
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
He then asserts :
2024–10–16 [ OO OLAOYE OYEBODE ]
Upvotes:
In schematic diagrams this is the symbol for a fuse:
What does a fuse do?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
It seems Mohan does not understand the difference between a comment and an Answer.
One
An AC voltage/ current source, and an ac inductive load.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
First Sentence:
The MOV will conduct when the voltage exceeds 50% of line voltage.
He then describes Rainy Season and Lightning.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
A circuit breaker is similar, but is resettable.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–10[John johnson John Johnson ]
but I think this circuit , shows a few more pieces.
Edit 2024–10.
This one hit behind the barn.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.